Announcement

Collapse
No announcement yet.

Cannot Access XPrintServer or see it on network

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Kevin
    replied
    Are you using IPv6 in your network only? The xPrintServer should be using an IP v address. A

    A continual blink indicates that the xPS is having trouble getting and IP address from the network. Is there an alternate network you can try to put this on with a DHCP with access to the Internet?

    The LED if constantly flashing a single flash is not getting an IP address.

    Leave a comment:


  • Jabrain
    replied
    This is what the router indicates after last attempt IPV6 Address
    2601:6c4:4000:326a::f51a Local Link IPV6 Address
    EMPTY MAC Address
    00:80:A3:98:5E:92 Comments

    Leave a comment:


  • Jabrain
    replied
    When I reset XPrintServer the x led flashed four times then stopped and flashed four times again and continued that pattern as long as reset button was held in. After 15/20 seconds, then both leds lit, then the left led stayed on indicating network connection. It connected to router, but then went offline. The X is now blinking on and off continuously.

    Leave a comment:


  • TechSupport2
    replied
    Does the XprintServer LED "X" just continually flash?

    Leave a comment:


  • Jabrain
    replied
    I followed instructions. The device showed online in router, but by the time I got back to safari to access the XPrintServer, it went offline. Thus no access. Repeatedly reset with same results

    Leave a comment:


  • TechSupport2
    replied
    First lets make sure you are resetting the device.

    1. Place the end of a paperclip or similar object into the reset opening (a pin-sized hole on the bottom of the xPrintServer) and press for a minimum of 15 seconds.
    2. Remove the paperclip to release the button.

    Then on the new router does the led "X" do a continual flash? or does it get to a slow fade in and out?

    If the Xprintserver keeps single flash...pause...single flash...pause, then the unit is not getting an IP address from the DHCP of the Infinity router. Try a different port on the router and or a different cable.

    Once it gets out of the single flash then you can go to http://findmyxps.com put in the MAC address (serial number) and get redirected to the web interface.

    See the quickstart at:https://www.lantronix.com/wp-content...-Office_QS.pdf

    Leave a comment:


  • Jabrain
    started a topic Cannot Access XPrintServer or see it on network

    Cannot Access XPrintServer or see it on network

    I changed from apple airport router to xfinity Gateway router. When I plugged in the XPrintserver (which worked perfectly with apple wifi), it showed up on new router as offline device. It gave Mac address 10.0.0.39, which did not allow anything when used. Using serial # in various iterations also did not allow access. Resetting Xprintserver umpteen times did nothing. So now it is a paperweight. I reset the xprintserver per manual several times. The lights on the xprintserver respond as indicated in users manual, but it will not connect to my network. I reconnected my apple airport and connected the xprintserver back to it, but that did not allow a connection either. IS THERE ANY HOPE TO RESOLVE THIS PROBLEM. This is what the Xfinity Gateway shows under offline devices.
    00:80:A3:98:5E:92 MAC Address
    00:80:A3:98:5E:92 Comments
    DHCP Ethernet
Working...
X